| Step | | Procedure & Parts & Tools |
| 1 |
|
REMOVE THE 14 SCREWS HOLDING THE BACK OF THE HANDLE.
| Screwdriver-phillips |
|
|
| 2 |
|
LIFT UP ON THE BACK OF THE HANDLE TO SEPARATE IT FROM THE FRONT OF THE HANDLE.
|
| 3 |
|
LOCATE THE FAT RED WIRE/CABLE AND THE AND THE FAT BLACK WIRE/CABLE GOING INTO THE CONTROL BOARD. TOUCH THE RED VOLT METER PROBE TO THE BOARD AT THE RED WIRE/CABLE AND THE BLACK VOLT METER PROBE TO THE CONTROL BOARD THE BOARD AT THE BLACK WIRE/CABLE. TURN THE VOLT METER ON AND SET IT TO VOLTAGE. IF THE VOLT METER READS 24 VOLTS, THE CONTROL BOARD IS GETTING POWER.
| Volt meter (True RMS capable) |
&Width=100)
|
|
| 4 |
|
REVERSE STEPS 1 AND 2 TO REASSEMBLE THE MACHINE.
|